Cadet The Com-Pak Plus Guida alla Risoluzione dei Problemi Scaricare il pdf

360-693-2505

Fax: 360-694-6939

P.O. Box 1675

Vancouver, WA

98668-1675

OWNER’S GUIDE

The Com-Pak

Plus

Keep for future reference

General Safety Information

30,48

25,4

17,46

10,16

8,26

3,17

29,21

4,13 3,81

30,48

41,27

36,83

8,26

10,16

29,21

8,26

The Com-Pak Plus

Model C

The Com-Pak Twin Plus

Model CT

C021 *C021T

C051 *C051T

C052 *C052T

C072 *C072T

C102 *C102T

C122 *C122T

C152 *C152T

C202 *C202T

C208 *C208T

C101 *C101T

C151 *C151T

Features & Benefits

■ Primary and Secondary Thermal

Safeguards

• Commercial grade high temperature

manual reset with 25 amp rating at

240 volt

• Over temperature one-time thermal

device

■ Nichrome element wrapped around

mica insulators for durability

■ Powder coat paint process eliminates

sharp cutting edges

■ Two year extended warranty

■ Wall can designed for ease of

installation

■ Factory tested

■ Made in the U.S.A.

Side

Front

Bottom

Grill Wall Can

Side

Front

Tools Required:

Phillips Screwdriver

Straight Screwdriver

Wire Strippers

Utility Knife

4 1

/2“ Wood Screws

3 Insulated Wire Connectors

1 Strain Relief Connector

The Com-Pak Twin Plus

CT252 *CT252T

CT302 *CT302T

CT402 *CT402T

CT408 *CT408T

*Standard built-in

thermostat is single pole

and has no OFF position

WARNING

Turn the electrical power off at the electrical panel

board (circuit breaker or fuse box) and lock or tag

the panel board door to prevent someone from

turning on power while you are working on the

heater. Failure to do so could result in serious

electrical shock, burns, or possible death.

1. Read all information labels. Verify that the electrical

supply wires are the same voltage as the heater.

2. All electrical work and materials must comply with

the National Electric Code (NEC), the Occupational

Safety and Health Act (OSHA), and all state and local

codes.

3. The heater must be grounded to the grounding pigtail

(copper wire) provided in the wall can.

4. If you need to install a new circuit or need additional

wiring information, consult a qualified electrician.

5. Protect electrical supply from kinks, sharp objects,

oil, grease, hot surfaces or chemicals.

6. WARNING

DO NOT install the heater in a floor or behind doors.

Overheating or fire may occur.

7. WARNING

DO NOT install heater in any area where combustible

vapors, gases, liquids, or excessive lint or dust are

present. Fire or explosion may occur.

8. WARNING

Risk of Electrical Shock. Connect grounding lead to

grounding wire provided. Keep all foreign objects out

of heater.

9. WARNING

Risk of Fire. Heater must be kept clear of all

obstructions: a minimum of 3 feet in front, 6” above

and on both sides. Heaters must be kept clean of lint,

dirt and debris. (See Maintenance Instructions)

Models:

The Com-Pak Plus

1 2 3 4

Sommario

Pagina 1 - The Com-Pak

360-693-2505Fax: 360-694-6939P.O. Box 1675Vancouver, WA98668-1675OWNER’S GUIDEThe Com-PakTMPlusKeep for future referenceGeneral Safety Information30,4

Pagina 2 - IMPORTANT!

Installation InstructionsHow do I install fornew construction?Figure 1Face of wall can mustextend 1/2" from face of studto allow for sheetrock.Th

Pagina 3 - How to operate your heater

Figure 7Figure 6Figure 8The Com-Pak Plus The Com-Pak Twin PlusInstallation InstructionsOperation & MaintenanceWiring DiagramsHow do I insert the h

Pagina 4 - Symptom Problem Solution

LIMITED TWO-YEAR WARRANTY: Cadet Manufacturing Co. will repair or replace, any Cadet Com-Pak Plus (C), and/or Com-Pak Twin Plus (CT)element or motor f